- 您现在的位置：买卖IC网 > Sheet目录868 > LTM4603HVEV#PBF (Linear Technology)IC DC/DC UMODULE 6A 118-LGA
LTM4603HV
APPLICATIO S I FOR ATIO
1.00
0.95
0.90
0.85
0.80
1-PHASE
2-PHASE
3-PHASE
4-PHASE
6-PHASE
0.75
0.70
0.65
0.60
0.55
0.50
0.45
0.40
0.35
0.30
0.25
0.20
0.15
0.10
0.05
0
0.1 0.15 0.2 0.25 0.3 0.35 0.4 0.45 0.5 0.55 0.6 0.65 0.7 0.75 0.8 0.85 0.9
DUTY CYCLE (V O /V IN )
4603HV F04
Figure 4. Normalized Output Ripple Current vs Duty Cycle, Dlr = V O T/L I
Figure 4 provides a ratio of peak-to-peak output ripple cur-
rent to the inductor current as a function of duty cycle and
the number of paralleled phases. Pick the corresponding
duty cycle and the number of phases to arrive at the correct
output ripple current ratio value. If a 2-phase operation is
chosen at a duty cycle of 21%, then 0.6 is the ratio. This
0.6 ratio of output ripple current to inductor ripple of 2A
equals 1.2A of effective output ripple current. Refer to Ap-
plication Note 77 for a detailed explanation of output ripple
current reduction as a function of paralleled phases.
The output voltage ripple has two components that are
related to the amount of bulk capacitance and effective
series resistance (ESR) of the output bulk capacitance.
Therefore, the output voltage ripple can be calulated with
the known effective output ripple current. The equation:
Δ V OUT(P-P) ≈ ( Δ I L /(8 ? f ? m ? C OUT ) + ESR ? Δ I L ), where f
is frequency and m is the number of parallel phases. This
calclation process can be easily ful?lled using the Linear
Technology μModule design tool.
Fault Conditions: Current Limit and Overcurrent
Foldback
The LTM4603HV has a current mode controller, which
inherently limits the cycle-by-cycle inductor current not
only in steady-state operation, but also in transient.
To further limit current in the event of an overload condition,
the LTM4603HV provides foldback current limiting. If the
output voltage falls by more than 50%, then the maximum
output current is progressively lowered to about one sixth
of its full current limit value.
Soft-Start and Tracking
The TRACK/SS pin provides a means to either soft-start
the regulator or track it to a different power supply. A
capacitor on this pin will program the ramp rate of the
output voltage. A 1.5μA current source will charge up the
external soft-start capacitor to 80% of the 0.6V internal
voltage reference minus any margin delta. This will control
4603hvf
12
发布紧急采购，3分钟左右您将得到回复。
相关PDF资料
LTM4603IV#PBF
IC DC/DC UMODULE 6A 118-LGA
LTM4604AIV#PBF
IC UMODULE DC/DC LV 4A 66-LGA
LTM4604IV#PBF
IC DC/DC UMODULE 4A 66-LGA
LTM4605EV#PBF
IC DC/DC UMODULE 5A 141-LGA
LTM4606MPV#PBF
IC DC/DC UMODULE 6A 133-LGA
LTM4607IV#PBF
IC BUCK/BOOST SYNC ADJ 5A 141LGA
LTM4608AEV#PBF
IC BUCK SYNC ADJ 8A 68LGA
LTM4608IV#PBF
IC DC/DC UMODULE 8A 68-LGA
相关代理商/技术参数
LTM4603HVEV#PBF
制造商:Linear Technology 功能描述:DC/DC Converter IC
LTM4603HVEV-1#PBF
制造商:Linear Technology 功能描述:6A 28V DCDC UMODULE: NO REMOTE
LTM4603HVEVPBF
制造商:Linear Technology 功能描述:6A 28V input DCDC uModule LTM4603HV
LTM4603HVEV-PBF
制造商:LINER 制造商全称:Linear Technology 功能描述:6A, 28VIN DC/DC μModule with PLL, Output Tracking and Margining
LTM4603HVIV#PBF
功能描述:IC DC/DC UMODULE 6A 118-LGA RoHS:是 类别:电源 - 板载 >> DC DC Converters 系列:µModule® 设计资源:VI-200, VI-J00 Design Guide, Appl Manual 标准包装:1 系列:* 类型:隔离 输出数:1 电压 - 输入（最小）:36V 电压 - 输入（最大）:76V Voltage - Output 1:5.5V Voltage - Output 2:- Voltage - Output 3:- 电流 - 输出（最大）:* 电源（瓦） - 制造商系列:200W 电压 - 隔离:* 特点:* 安装类型:通孔 封装/外壳:9-FinMod 尺寸/尺寸:4.60" L x 1.86" W x 1.05" H（116.8mm x 47.2mm x 26.7mm） 包装:散装 工作温度:-10°C ~ 85°C 效率:* 电源（瓦特）- 最大:*
LTM4603HVIV#PBF
制造商:Linear Technology 功能描述:DC/DC Converter IC
LTM4603HVIV-PBF
制造商:LINER 制造商全称:Linear Technology 功能描述:6A, 28VIN DC/DC μModule with PLL, Output Tracking and Margining
LTM4603HVV
制造商:LINER 制造商全称:Linear Technology 功能描述:6A, 28VIN DC/DC μModule with PLL, Output Tracking and Margining